Toyota — Clutch

CLUTCH AIR BLEEDING Dry Clutch Models (STD) Note: During air bleeding operation, add brake fluid from time to time to prevent the level from becoming insufficient. 1. Bleed air from the clutch release cylinder. (1 Depress the clutch pedal several times to compress the air in the piping and keep that state. (2) Loosen the breather plug to bleed air in the piping with the brake fluid and tighten the plug immediately be - fore the discharge stops. (3) Repeat steps (2) until no air bubble is seen in the discharged brake fluid. (1) and 2. Add brake fluid to the specified level. Oil Clutch Models (OPT) 1.

While running the engine at idle, slowly push the clutch release cylinder output rod slowly into the cylinder to the stroke end. Push it in again after returning to the out end. Repeat this five cycles. Note: Do not depress the clutch pedal.