Release Cylinder Adjustment (Oil Clutch) 1. Adjust the release cylinder rod length. (1) Keep the release cylinder piston in contact with the cylinder bottom and bring the push rod into contact with the piston. Adjust the push rod length in this state to make the clearance (dimension A ) between the release bearing and clutch release lever (release bearing plate) satisfy the following standard. A = 1 - 2 m m (0.04 - 0.08 in) (It is allowed to adjust dimension B as push rod stroke B = 2 - 4 m m (0.08 - 0 . 1 6 in) when A = 1 - 2 mm (0.04 - 0.08 in)) (2) Start the engine, and bleed air from the release cylinder. (See page 2 - 22.)