Mitsubishi — 2.3 Installing fuel injection pump camshaft

REASSEMBLY OF BASIC ENGINE 2. Reassembling gear case, timing gear and camshaft 2.1 Installing front plate (1) Clean the mounting surface of the gasket. (2) Apply sealant to the gasket to prevent it from falling. (3) With aligning to the dowel pin, install the gasket and the front plate. (4) Secure the front plate with mounting bolts. Fixing bolts of front plate: 7 Installing front plate 2.2 Rotating crankshaft (1) Install two bolts in the flywheel mounting holes of the crankshaft. (2) Rotate the crankshaft with a bar using the bolts to bring the No.1 cylinder at the top dead center.

Turning engine 2.3 Installing fuel injection pump camshaft (1) Insert the fuel injection pump camshaft (with the bearing and gear installed) into the cylinder block hole. (2) Install the bearing into the cylinder block hole completely by tapping the gear with a plastic hammer. (3) Make sure that the fuel injection pump camshaft rotates lightly. (4) Tighten the camshaft stopper bolts. Driving in fuel injection pump camshaft Camshaft stopper washer Fuel injection pump camshaft gear Installing camshaft stopper washers 7-9