Mitsubishi — 2.1.1 Inspecting and adjusting fuel injection valve opening pressure

FUEL SYSTEM 2.1.1 Inspecting and adjusting fuel injection valve opening pressure Nozzle tester &$87,21 Never touch the injection nozzle tip during nozzle injection test. (1) Mount the nozzle on the nozzle tester. (2) Push down the handle at a speed of once a second and read the pressure when injection starts. Make adjustment if it is outside the standard. (3) To adjust the injection start pressure, remove the set screw on the nozzle holder, loosen the cap nut and turn the adjusting screw with a driver. (4) After adjustment, tighten the cap nut and set screw with the specified torque. (5) After tightening the set screw, check if the injection start pressure is within the standard again.

Checking valve opening pressure Nozzle tip end Note: Change in washer thickness by 0.1 mm [0.004 in.] results in a pressure change of 1.0 MPa {10 kgf/cmІ} [142 psi]. Washers are available in 10 different thicknesses at intervals of 0.05 mm [0.0020 in.] in the range between 1.25 and 1.70 mm [0.0492 and 0.0669 in.]. Replacing fuel injection nozzle tips 8-9 Item Standard Valve opening pressure 13.73 to 14.73 MPa {140 to 150 kgf/cm²} [1992 to 2134 psi]