FUEL SYSTEM 2.9.2 Reassembling torque spring set, double spring type Reassemble the torque spring set of the double spring type as described in the following. (1) Screw in the adjusting screw so that the end of the spring stopper protrudes from the torque spring case as the protrusion table below. (2) Then, tighten the locknut to the specified torque to secure the adjusting screw. (3) With the spring stopper pushed in as described above (1), make sure the spring stopper moves smoothly and is properly retracted to the end face of the torque spring case. (4) To check the protrusion of the spring stopper is correctly adjusted, place the torque spring set as shown in the illustration.
Apply a dial gauge to the end of the spring stopper and set the pointer to zero. Then, push in the spring stopper and slightly displace the torque spring set to the side. Read extension of the dial gauge to the end of the torque spring case. Special nut Lock nut 7.8 to 11.8 N 㨯 m {0.8 to 1.2 kgf 㨯 m} [5.8 to 8.7 lbf 㨯 ft] Spring stopper Torque spring case Protrusion amount Torque spring Adjusting screw Setting of torque spring of double spring type Dial gauge Push in spring stopper.
Spring stopper Torque spring case Measuring protrusion of spring stopper of double spring type 8-22 Protrusion mm Color 0.2 to 0.3 mm [0.008 to 0.012 in.] None 0 to 0.4 mm [0 to 0.016 in.] White 0.3 to 0.4 mm [0.012 to 0.016 in.] Blue 0.4 to 0.5 mm [0.016 to 0.020 in.] Black 0.6 to0.7 mm [0.024 to 0.028in.] Pink 0.5 to 0.6 mm [0.020 to 0.024 in.] Orange