Mitsubishi — 2.1.1 Inspecting pinion clearance

ELECTRICAL SYSTEM 2. Disassembling, inspecting and reassembling electrical system 2.1 Inspection before disassembling starter (M000T60481 (12V-1.2kW), M001T68381 (12V-1.7kW)) 2.1.1 Inspecting pinion clearance &$87,21 Do not apply current continuously for longer than 10 seconds. SW1 SW2 B S M (1) Connect the starter to the circuit as shown in the illustration. (2) When the switches SW1 and SW2 are turned ON, the pinion springs out to the cranking position and the armature rotates. (3) Turn the switch SW2 OFF to stop the rotation of the armature. (4) Gently push back the pinion in the out position with a finger and measure the distance over which the pinion has returned (movement amount).

(5) If the measured value is out of the standard, increase or decrease the number of packings between the magnetic switch and the front bracket for adjustment, or replace the lever with a new one. Note: When the number of packings is increased, the pinion clearance becomes small. Battery 12V Disconnect the lead with a terminal connected to terminal M. Wiring during inspection of pinion clearance Pinion Gently push back the pinion. Pinion clearance 0.5 to 2.0 mm [0.0197 to 0.0787 in.] Inspecting pinion clearance 12-8 Item Standard Pinion gap 0.5 to 2.0 mm [0.0197 to 0.0787 in.]