ELECTRICAL SYSTEM 2.3 Preparation before disassembling Mark the mating marks on magnetic switch, front bracket, center bracket, yoke and rear bracket to each other for reassembly. Preparatory work before disassembly 2.3.1 Removing pinion set &$87,21 The starter generates heat if it is left with current being applied. Remove the pinion within 10 seconds. SW1 SW2 B S M (1) Connect the starter to the circuit as shown in the illustration. (2) Turn the switches SW1 and SW2 ON to move the pinion out and then turn the SW2 OFF to stop the rotation of the armature and the pinion. (3) Place an appropriate tube on the pinion stopper.
Tap the tube with a hammer to drop the pinion stopper to the clutch side. This will expose the stopper ring. (4) Remove the stopper ring with pliers and remove the pinion. Note: Do not reuse the stopper ring for reassembly. Battery 12V Disconnect the lead with a terminal connected to terminal M. Connection to move the pinion forward Stopper ring Pinion stopper Pinion Removing pinion 2.3.2 Removing magnetic switch Disconnect the leads, and remove the magnetic switch. Screw Magnet switch Removing magnetic switch 12-12