ELECTRICAL SYSTEM 2.9.6 Adjusting pinion shaft end play Adjust the end play (thrust gap) to 0.5 mm [0.0197 in.] or less by inserting adjusting washers between the center bracket and reduction gear. (1) Install the pinion shaft, reduction gear, washer and snap ring onto the center bracket. (2) Measure the pinion shaft end play by moving the shaft in the axial direction. If the measured value exceeds 0.5 mm [0.0197 in.], make an adjustment by adding adjusting washer(s). Adjusting washer Reduction gear Washer Snap ring Maximum of 0.5 mm [0.0197 in.] End play Adjusting pinion shaft end play 2.9.7 Installing bearing Install the bearings on both ends of the armature.
Rear bearin Front bearing Armature Installing bearings 2.9.8 Installing armature, yoke, brush and brush holder (1) Align the knock pin with the center bracket and reassemble the armature to the yoke. (2) Reassemble the brush holder and brushes. Brush holder Brush Yoke Armature Installing brush holder 12-37