Mitsubishi — 2. Testing compression pressure

DETERMINATION OF OVERHAUL 2. Testing compression pressure &$87,21 (a) Be sure to measure the compression pressure for all the cylinders. It is not a good practice to mea- sure the compression pressure for only one cylin- der, and presume the compression for the remaining cylinder. (b) Also be sure to check engine speed when measur- ing the compression pressure, as compression pressure varies with engine speed. (c) Measuring the compression pressure at regular in- tervals is important to obtain correct data. (d) When measuring the compression pressure for cylinders one by one, do not remove other fuel injection nozzles from their positions, except for the one being measured.

Compression gauge Compression gauge adapter P/N:ST332270 Testing compression pressure (1) Remove the injection nozzle from the cylinder head where the compression pressure is to be measured. (2) Remove the glow plugs from all cylinders. (3) Attach the compression gauge adapter to the injection nozzle mount, and connect compression gauge. (4) Stop the fuel supply. (5) Crank the engine with the starter, then read the compression gauge indication while the engine is running at the specified speed. (6) If the compression pressure is lower than the limit, overhaul the engine.

4-3 Item Standard Limit Engine speed 280 min-1 - Compression pressure 2.7 MPa {28 kgf/cm²} [398 psi] Not acceptable at or below 2.2 MPa {22 kgf/cm²} [313 psi] Difference between each cylinder Within 0.25 MPa {2.5 kgf/cm²} [36 psi] -