. OPERATION OPERATION CANCELING DUMP BODY HOLD CONDITION WARNING STOPPING ENGINE down 3 - 88 If th e HOLD is cance led when the dump body is raised, the body wil l go down under its own weigh t. This is very dangerous. Always lower the du mp body before stopping the Afte r the engine ha s been started, if the dum p lever is operate d to HOLD, the dump body is held in position until the leve r is operated to FLOAT, RAISE, or LOW ER. Afte r starting the e ngine, the body pilot lamp lights up, so ope rate the dump lever from H OLD to FLOAT to cancel the body hold cond ition.
With this operation, when the dump body moves to the FLOAT condition, the body pilot body condition, the body pilot lam p goes out. NOTICE If the engine is sud is danger that the denly stopped without allowing it to cool down, t life of the engine parts will be shortened, so n s A A top the engine su llow the engine t fter the engine is ddenly except in emergency o cool down gradually befor stopped, the dump body is h . e stopping it. eld at the same posi re F gardless of the p osition of the dump lever. S et the dump lever to LOAT position, l ower the dump body, then st op the engine. 1. Set the shift lev er to the N position, then set the parking br switch to the P ARKING position.
p body and set the dump lever to the H e at low idle for about 5 minutes to cool d 2. Lower the dum position. 3. Run the engin gradually. 4. Turn the key o f starting switch (1) to the OFF position to the engine. y from starting switch (1). 5. Remove the ke y from starting switch (1) CHECKS AFTER STOPPING ENGIN E 1. 2. 3. 4. 1. Walk around th e machine and check the work equipment, bodywork, and undercarria ge, and check also for oil and water leak age. k. ine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard. ud affixed to the undercarriage. 2. Fill the fuel tan 3. Check the eng ine compartment for pape r and debris. Cle an out any paper and debris 4.
Remove any m ud affixed to the underca