Komatsu — LOADING OPERATIONS

. OPERATION OPERATION lock below, use a bulldozer to 3 - 104 (C): Manual actuation of inter-axl e differential lock, and actuation o f front, cente r, rear axle le ft and right differential U se this when the maximum r REM If the tires slip or there is a diff erence in the rotating speed of the tires when t he inter-axle differential loc k switch at AUTO, the inter-axle diffe rential lock is automatically actua ted to set to condition (C W hen the left and right differe ntial lock is actuated, the steering wheel will b ecome more difficult to operate , so e particularly careful when tr WHEN TIRES ARE STUCK IN GROUND e wheels from spinning, do as follows.

If the wheels get stuck, to stop th e wheels from spinning, do as fol If it i s impossible to get the mac hine out. hine out even when repeating the procedure mac tow the elease the accelerator ped al to stop the wheels from spinnin g. differential locks. ctuate the inter-axle differe ntial lock and all the left and right differential lo epress the left and right diff erential lock pedal, set to the gea rshift lever t o position "5" , and raise the engine peed. al and brake pedal. elease the accelerator ped epress the left and right diff erential lock pedal, set to the gear shift lever to position "R1 ", and raise the engine peed. he machine backwards and forwards until it can escape.

epeat Steps 1 - 5 to move t he machine backwards and forwa rds until it c LOADING OPERATIONS Whe n using a large wheel loader to load large rocks, if the rocks ar e loaded dire ctly into the d ump body part s of the dum p body may be deformed. To prevent this, when loading large rocks, first lo ad sand or s oil to act as a c ushion, then load the rocks on top of this to reduce the impact on the dum p body. In ad dition, when loading rocks t hat exceed the following condition s, install the optional dum p body reinforcement plate .

ocks with one side over 0.3 m (11.8 in) ocks of hardness more than 4.5 (Mohs scale) ocks with a weight of more than 150 kg (331 lb) hen transporting steel ingots R ocks with one side over 0.3 R ocks of hardness more than R ocks with a weight of more t W hen transporting steel ingots NOTI CE hen traveling, always set the dump lever to the FLOAT position regardless of whether the dump body is empty or loaded. W hen traveling, always set the du mp lever to the FLOAT position regard less of wheth er the dump b ody is empty or loaded.

If t he dump lever is not at the FLOA T position and the shift lever is not at the N position , the central w arning lamp will f lush and th e alarm buzzer will sound.