. OPERATION TROUBLESHOOTING 1. Remove cover (2) from the rear of hydraulic tank (1). 2. Loosen locknut (4) of manual lower valve (3). 3. Turn grip (5) of valve (3) counterclockwise. The oil in the hoist cylinder is drained into the hydraulic tank and the dump body lowers. 4. Tighten grip (5) and locknut (4) and install cover (2). 3 - 126 IF TRANSMISSION HAS T If th e transmission has any troub le, operate the machine according t o the fol lowing pro Decelerate the machine wit place. h the brake and stop it on a safe Set the shift lever to the N po sition, then set the parking brake switch to the PARKING posi tion.
In some trouble modes, the gear is not shifted even if the shift lever is operated. owing procedure. In this case, perform the foll 1) Disconnect emergency A-2, 1-pole White conne 2) Set the parking brake sw 3) Operate the shift lever to without depressing the a escape connectors (1) (No. A-1, ctor) and connect them again. itch to the TRAVEL position. move the machine to a safe place ccelerator pedal. If th e gear shift lever is operated with the accelerator pedal depressed , the em ergency es cape function will n ot work. In a ddition, the emergency esca pe function may not work for some f ailure co des.
Whi le the emergency escape fun ction is working, the shift indicator of the mac hine monit or displays "E" and the shift ran ge (gear speed) of the transm ission alternately. METHOD OF LOWERING DUMP BODY IN EMERGENCY Wh en the dump body needs to b e lowered to the seat while the engin e canno t be started for some trouble, perform the following procedure. If the dump body does not go down even when the above method is used, please cons ult your Komatsu distributor.