. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING 4 - 56 EVERY 500 HOURS SERVIC E Maintenance for every 50 and 250 hours service should be carried out at the same tim The parts and oil are at high temperat ure after the engine isstopped, and may cause burns. Wai tfor the temperature to go down before starting the work. Refill capacity: 50 liters (13.21 U Prepare a filter wrench 1. Remove the bolts and cover (1 2. Place a drain oil container just 3. Remove drain plug (2), then lo osen drain valve (3) slowly to d drain the oil.
Be careful not to d deform the stopper pin inside f there are excessive metal please contact your Komatsu in plug (2). 8.6 ± 9.8 Nm ± 1 kgm , 50.6 ± 7.2 lbft) lter cartridge (4) to the left to ting oil on yourself, do not carry ately under the cartridge. carried out immediately after ount of oil will come out, so wait he operation. ew filter cartridge with oil, coat h oil (or coat thinly with grease), n doing this, be careful not to damage the outside cylinder of the cartridge. avoid getting oil on yourself, an loosen the drain valve too far an the valve. Check the drained oil, and i particles or foreign material, distributor. 4. 5.
Tighten drain valve (3) and dra Tightening torque Drain plug (2), drain plug (3): 6 (7 6. Using the filter wrench, turn fi remove it. When doing this, to prevent get out this operation from immedi In particular, if this operation is stopping the engine, a large am for 10 minutes before starting t Tightening torque Drain plug (2), drain plug (3): 6 6. When doing this, to prevent get out this operation from immedi In particular, if this operation is stopping the engine, a large am for 10 minutes before starting t 7. Clean the filter holder, fill the n the packing face and thread wit then install the filter cartridge. 8. Install the filter cartridge.
Whe n doing this, be careful not to damage the outside c ylinder of the cartridg When installing the filter cartrid ge, tighten until the packing face is in contact with t he filter holder, then ti ghten a further 3/4 to 1 turn. engine oil from oil filler (F). e at idle, then check the oil if it is filled up to a specified level. For details, see E OIL PAN, ADD OIL (PAGE 3-74)". 9. Pour in the specified amount of 10. Run the engine for a short tim "CHECK OIL LEVEL IN ENGIN