. MAINTENANCE SERVICE PROCEDURE LUBRICATE CAB MOUNT PIN (LEFT AND RIGHT: 1 PLACE EACH) 1. Stop the engine. 2. Using a grease pump, pump in grease through the grease fittings shown by arrows. CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING mark is at the top 4 - 58 9. When installing, tighten until the packing surface contacts the seal surface of the filte r holder, then tighten it 3/4 of a turn. If the filter cartrid filter cartridge is When tighteni ge is tightened too far, the packing will be damaged and this will lea d to leakage of fuel. If the too loose, fuel will also lea k from the packing, so always tighten the correct amount. the filter. rely.
ng with a filter wrench, be extremely careful not to dent or damage 10. Check that the d rain plug at the bottom of t he water separator cup is tightened secu Tightening torqu e: 0.2 to 0.45 Nm (0.02 to 0.046 kgm, 0.1 to 0.3 lbft) 11. After replacing t he fuel main filter cartridge (at intervals of 1,000 hours), bleed air. F or details, see "REPLACE FUEL MAIN FIL TER CARTRIDGE (PAGE 4-64)". Do not add fuel to the fuel main fi lter cartridge, however. 12. Start the engine, check that there is no l eakage of fuel from the filter seal surface or water separator mounting surface, then ru n for approx. 10 minute s at low idling. 3.
After greasing, w ipe off any old grease that The parts and oil ar e at high temperature after the engine is stopped, and may cause serious bu rns. Wait for the temperature to go down before s tarting the operation. If there is still press ure remaining inside the case, t he oil or plug may fly out. Turn the plug slowly to release the pressure, then remove it carefully. 1. Stop the machin and drain plug ( 2. Remove plug (G ) and check that the oil l eve of the plug hole. 3. If the oil level is t oo low, add oil through the oil overflows. 4. Repeat the proc edure in Steps 1 - 3 and add oil to all the final drive cases (front,