OPERATION 7. KICKDOWN SWITCH When the speed control lever is in 2nd, and the switch at the top of the knob of the work equipment control lever is pressed, the transmission will shift down to 1st gear. This switch is used to increase the drawbar pull in digging operations. REMARKS To cancel the kickdown switch, move the directional lever to REVERSE or NEUTRAL, or move the speed control lever to any position except 2nd. It is also possible to cancel the kickdown switch by operating the parking brake switch or by turning the starting switch OFF. 8.
ATTACHMENT SWITCH (bucket / fork selection) Located on the control lever console, the switch activates the appropriate bucket/fork positioner proximity switch. When using a bucket select the bucket position on the attachment switch. When using a fork select the fork position on the attachment switch. 9. DUMP SPEED SWITCH Located on the control lever console, the two position switch allows the operator to select a slow or fast tilt cylinder dump speed. A significant increase in the dump speed occurs when the fast speed is selected. The tilt back speed is not affected by this switch. 10.
QUICK COUPLER ATTACHMENT SWITCH Located on the control lever console, the momentary contact switch activates the coupler plungers to couple and uncouple attachments. Pushing the switch to the unlock position disengages the coupler plungers from the attachment. Releasing the switch extends the plungers and engages the coupler plungers to the attachment. Refer to coupling and uncoupling procedure in this section. 2-12