3.5 OPERATING THE HEATER, VENTILATION AND AIR CONDITIONING OPERATION 3.5 OPERATING THE HEATER, VENTILATION AND AIR CONDITIONING Legend for illustration Z25448 (1) Switch, cab ventilation blower. (2) Heater and air conditioning control panel (3) Cab heating control (4) Cab heating blower control (5) Control module for the engine independent auxiliary cab heater (if so equipped). This module is used for switching ON and OFF the auxiliary cab heater during operation of the shovel with the Diesel engines running, and for pre-selec- tion of heater start times and duration of heating periods with engines off.
For detailed setting instruc- tions of the control module refer to the separate operating instruction sheet in volume 2 binder. (6) Button for actual time indication (7) Button for preselection of heating time (8) Button for heating indication (9) Button for settings backwards (10) Button for settings forward (11) Not used (12) Display shows the operating condition of the heater (13) Thermostat for engine independent cab heater (if so equipped). This unit is used to maintain a desired temperature in the cab during standstill periods of the shovel. The battery main switches and the pre-heating system main switch must be in ON position. See page 147 for more information.
The fuel shut-off cock for the water heater HYDRONIC must be in open position, see page 125 for more information. Activate the heater with control module (5). (14) Temperature selector button (if so equipped) (15) Air conditioner temperature control knob. To lower the cab air temperature (maximum cooling output) rotate the control knob to the left (-) sign. To reduce cooling output rotate the knob to the right (+) sign. (16) Air conditioner blower control knob (17) Indicator light, air conditioning ON (18) Indicator light, air conditioning blower ON 122