OPERATION 3.7 ELECTRICAL EQUIPMENT IN CAB BASE Pre-heating System (continued) Engine Coolant and Engine Oil Heatings REMARK Use the heating system during stand-still periods e.g. over night and low ambient temperatures. The heating system should be energized as soon as the engine is stopped. This allows the heating system to maintain the desired temperature with the use of minimum power. Legend for illustration Z 22892 (1) Coolant heating system, installed on LH side mem- ber of the main frame. (2) Switch, coolant heater ON/OFF. (3) Indicator light, coolant heating ON, (4) Coolant hose from engine to coolant heater (5) Coolant hoses, preheated coolant to the engine.
(A) Coolant inlet (B) Coolant outlet (C) Engine oil heater installed in the engine oil pan (D) Thermostat for engine oil heater installed in the engine oil pan REMARK The engine oil reserve tank is also equipped with a heater element and thermostat, see next page for details. To activate the coolant heating, set main switch (1Q1) on the switch board in cab base to ON position. The coolant heating can then be switched on with switch (2) on the control panel. The lamp (3) illuminates with coolant heating ON. NOTICE Before starting the shovel engine, switch OFF the coolant heater.
REMARK For more information about the coolant heating system, refer to the manufacturer’s manual -KIM HOTSTART Coolant Heating System- delivered with the heating system. 151