Komatsu — 3.7.3 COMPONENTS OF ELECTRICAL PRE-HEATING SYSTEM LOCATED IN THE CAB BASE

OPERATION 3.7 ELECTRICAL EQUIPMENT IN CAB BASE Pre-heating System (continued) Heaters for Hydraulic Oil Reservoirs, PTO Housing, Engine Oil Reserve Tank and Batteries, illustration Z 22893 (1) Junction box for hydraulic oil heating (2) Switch, hydraulic oil heating ON / OFF. (3) Warning light red, heating system failure, (4) Indicator light green, hydraulic oil heating ON.

(5) Immersion heaters installed in the suction oil reser- voir and engine oil reserve tank (6) Immersion heaters installed in the main hydraulic oil reservoir (7) Immersion heater installed in the PTO (pump distrib- utor gear) (8) Thermostats installed in the main oil reservoir, suc- tion oil reservoir, PTO (pump distributor gear) and in the engine oil reserve tank (9) Adapter flange for heater element (10) Heater plates for batteries REMARK The batteries are located below the rear walk- way floor plates in the engine room.

(A) Location of immersion heaters (6) at the main oil res- ervoir (B) Location of thermostats (8) at the main oil reservoir and engine oil reserve tank (C) Location of immersion heaters (5) at the suction oil reservoir and engine oil reserve tank 153