OPERATION 3.19 CENTRAL REFILLING SYSTEM 3.19.3 RECEIVER PANEL WITH MONITOR BOX Legend for illustration Z 21623: NOTICE The two-loop type engine cooling system is equipped with two radiators. One radiator for the engine crankcase and cyl- inder heads and one radiator for the low temperature after- cooler (LTA) system. The radiators are connected with a pipe on the bottom side. This pipe contains a check valve which allows coolant flow from rear engine radiator to the front LTA radiator only. For draining the coolant from the front mounted LTA radiator, it is necessary to open the shut-off cock in the draining/filling hose line just below the radiators.
Refer to the engine Operation and Maintenance Manual in part 3 of this binder for the maintenance instructions of the cooling system. Be sure to close the shut-off cock on the bottom side of the radiators as soon as the maintenance of the cooling system is finished. 217 3 Service arm, hydraulically operated 4 Monitoring and control box 5 Receiver panel 6 Fuel filling adapter REMARK The fuel nozzle cut-out pressure should be adjusted to 0,38 bar. If this pressure is too low for filling the fuel tank up to the correct level, gradually increase the cut- out pressure until the pressure is sufficient for filling up to the correct level The maximum flow rate should not exceed 680 liter per minute.
7 Filling adapter for engine oil reserve tank of the reserve system 8 Push button for testing lamps (9, 13, 15 and 17). Push the button, all lamps must light up. If a lamp does not light up, corrective action must be taken. 9 Indicator light, engine oil reserve tank full. 10 Engine oil evacuation and filling adapter connected to the engine oil pan. Monitor oil level at level gauge. 11 Radiator coolant draining and filling adapter. Monitor coolant level at radiator filler neck. CAUTION CAUTION