MAINTENANCE 4.12 EVERY 1000 OPERATING HOURS OR EVERY 6 MONTH FILTER SERVICE Replace Pressure Oil Filter Elements, illust. Z 23026 NOTICE If a fault message "Trouble oil filter...." is displayed, stop the engine and replace element of the respective pressure filter. Legend for illust. Z 23026 (1) Central control and filter carrier (2) Pressure oil filter, hydraulic oil cooler fan drive (3) Pressure oil filter, pump regulation and pilot circuit (4) Pressure oil filter, PTO gear lubrication (5) Pressure oil filter, engine radiator fan drive Replace filter element (F) as follows: 1. Place working attachment on the ground and shut-off the engine.
Relieve pressure in the hydraulic system with several move- ments of the control levers. 2. Place a suitable container below the filter in order to collect outflowing oil. 3. Remove plug (A) and drain the oil. 4. Unscrew case (C) of the respective filter and clean the filter case. 5. Discard element (F) with O-ring (G). 6. Inspect O-ring (D) and back-up ring (E), replace if necessary. 7. Install drain plug (A) with new packing ring (B). 8. Lubricate the thread at the filter head and at filter case (C) with multi-purpose grease K2K. 9. Insert a new element (F) with new O-ring (G). 10. Fill the case (C) half way up with clean hydraulic oil. 11. Screw the case (C) into the head and tighten. 12.
After short operating period check filter for leakage. 13. Check restriction indicator (H) for proper mounting and good condition. 377