Komatsu — 3.3.7 INTERFACE PANEL FOR DIAGNOSTICS AND CONTROLS FOR HEATING AND AIR CONDITIONING

OPERATION 3.3 OPERATOR’S CAB - CONTROLS 3.3.7 INTERFACE PANEL FOR DIAGNOSTICS AND CONTROLS FOR HEATING AND AIR CONDITIONING Legend for illust. (Z25447) (1) Interface panel on rear operator’s console (X27A) Data link connector for download of VHMS memory data (S49) Reset button for VHMS monitor (X13) Data link connector for Electronic Tool connection to the electronic pump control system MC7 (X15.1) Data link connector for Electronic Tool connection to the ECM of the engine monitoring system CENSE (X52.1) Data link connector for Electronic Tool connection to the ECM of the engine control system QUANTUM (S53) Enable switch for Cense and Quantum diagnostic.

For download of engine data and for programming the Cense and Quantum ECM stop the engine and set main key switch to off position, then turn on switch (S53). For checking active fault codes of the engine via service lamps H94, H95 and H96 located on switch board (X2) in the cab base use the same procedure described above. Refer to page 141 for more information. (2) Portable fire extinguisher. Observe the local Fire Prevention Regulations in regard to number, size and location of portable fire extinguishers. Make sure the fire extinguisher is always charged and ready for use. (3) Cab heating control (4) Cab heating blower control 93