Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL WARNING Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. for when the the engine "ENGINE 3 - 79 1. Stop the engine a nd wait for the temperature at a ll parts to go REMARK When checking the oil level after the engine has b een operated , wait for at least 15 min utes after stopping the engine before chec king. Checking the oil lev el with the engine idling may be allowed, if th e following precautions a re thoroughly satisfied:

o Check that the en gine water temperature gauge shows green o Use the side of th e dipstick marked "ENGINE ID o Remove the oil fil If the machine is at an angle, make it horizontal be fore checkin 2. Open the engine s ide cover at the rear left of the 3. Take out the dipst ick (G) and wipe off the oil with 4. Fully insert dipstic k (G) into filler pipe, then remov 5. The oil level shoul d be between the H and L mark (G). If the oil level is be (F). The dipstick has le the levels for mea STOPPED) and t engine is idling (E When measuring stopped and use STOPPED". 6. If the oil is above t he H line, install a hose to the of drain plug (P), d again. rain the excess oil, then check 7.

If the oil level is co rrect, tighten oil filler cap (F) se remove the hose and close the engine side cover