. OPERATION OPERATION NORMAL OPERATION checks. 3 - 94 After the e ngine starts, do not start op erating the machine immediately. First, carry out the following operations and NOTICE Do not sud denly accelerate the engine bef ore the warming-up operation is completed. Do not run the engine at low idle or high idle continuously for more than 20 minutes. If it is nece ssary to run the engine at idle, apply a load from time to time or 1. Imme diately after starting the en gine, without depressing t gine at idle for at least he accele secon during rator pedal (1), run the en 10 ds during the warm weathe r and for at least 15 seconds the cold weather. 2.
Depre ss accelerator pedal (1) ligh tly and run the engine with no load a t midrange speed for about 5 minutes. 3. In col d weather only, carry out the following operation to warm up the Durin rotatio FREE Move warm Keep secon press hydraulic oil. g the warming-up operati on, check that the engine n is smooth, then set work position (F). bucket control lever (3) in a up the hydraulic oil. equipment lock lever (2) to nd out of the TILT position to to the relief time at the TILT p ds. If this is done, the hyd ure, so the oil is warmed up osition to a maximum of 10 raulic oil reaches the relief more quickly. p operation, check that the al. out maintenance or repair. 4.
After carrying out the warming-u gauge If any Run t tempe gauge s and pilot lamps are norm abnormality is found, carry out maintenance or repair he engine under a light l oad until the engine water rature gauge (4) and torqu e converter oil temperature color, noise, or vibration. If r Komatsu distributor. (5) enter the green range. 5. Check for abnormal exhaust gas any pr oblem is found, contact you