. OPERATION OPERATION ADJUSTING TRANSMISSION CUT-OFF POSITION CAUTION the operation. Transmission cut-off pilot lamp (4) will light up. beep) and the cut-off position is set. Method of returning to default setting 2 3 - 107 Apply the parking brake before adjusting the tr ansmission cut-off Adjust the depre ssion position of the left br ake pedal use d to shift the t ransmission to neutral a t the position to match 1. Start the en gine with starting switch (1 ), then set parking brak switch (2) to 2. Turn transm the ON position. ission cut-off switch (3) O N. 3. Depress left brake pedal (5) and adjus t it to the position wher to shift the transmission t 4.
Press trans mission cut-off set switch ( 6), then releas e it. At th the switch is released, the buzzer will sound (bee 5. After the bu press trans zzer sounds in Step 4 of th mission cut-off set swit e adjustment p ch (6) again rocedur within seconds, an d release it. will sound with a long sound and the adjuste ion is canceled. position is returned to the default setting. 6.
The buzzer cut-off posit The cut-off position is returned to the default setting Transmission cut When the trans mission cut-off switch is O N, if the brake pedal is depressed, the transmission is returned to Neutra when the brake pedal is depressed to the REMARK nsmission cut-off switch is OFF, the transmission does not return to Neutral. When the tra nsmission cut-off switch i s OFF, the transmissio n does not return to Neutral Even if the le ft brake pedal is not depre ssed, it is possible to se t the transmission cut-off po sition, but in that case, it is set to the default position (the posi tion where the brake p edal is depressed least).