Komatsu — ADJUSTING WORK EQUIPMENT POSTURE

. OPERATION OPERATION ADJUSTING WORK EQUIPMENT POSTURE WARNING 3 - 135 Stop the machine on level ground a nd put blocks in front of and behind the tires. Turn the parking brake switch ON. the frame lock bar. work equipment control levers. nt when the arm is raised. Lock the front and rear frames with Always hang a warning tag on the Do not go under the work equipme ADJUSTING BUCKET POSITI ONER nd, set it to the desired digging 1. Lower the bucket to the grou angle, return the bucket contro the work equipment lock lever the engine. 2. Loosen two bolts (1) and adj proximity switch so that the rea center of the sensing surface tighten the bolts to hold the br 3.

Loosen two nuts (5) and adju mm (0.12 to 0.20 in) between of proximity switch (3). Then ti Tightening torque: 14.75 to 19 14.5 lbft) 4. After adjusting, start the engin the bucket control lever to the to the TILT BACK position automatically returned to the reaches the desired digging a 1. Lower the bucket to the grou angle, return the bucket contro l lever to the HOLD position, set the work equipment lock lever to the LOCK position, then stop the engine. Loosen two bolts (1) and adj ust mounting bracket (4) of the 2. proximity switch so that the rea r tip of angle (2) is in line with the center of the sensing surface of proximity switch (3). Then acket in position.

st to make a clearance of 3 to 5 tighten the bolts to hold the br 3. Loosen two nuts (5) and adju mm (0.12 to 0.20 in) between bar (2) and the sensing surface of proximity switch (3). Then ti ghten the nuts to hold in position. Tightening torque: 14.75 to 19 .65 Nm (1.5 to 2.0 kgm, 10.8 to 4. After adjusting, start the engin e and raise the lift arm. Operate the bucket control lever to the DUMP position, then operate it to the TILT BACK position and check that the lever is automatically returned to the HOLD position when the bucket reaches the desired digging a ngle.