Komatsu — WHEN MACHINE RUNS OUT OF FUEL

. OPERATION TROUBLESHOOTING TROUBLESHOOTING PROCEDURE FOR BLEEDING AIR CAUTION Tightening torque: 7.8 - 9.8Nm {0.8 - 1.0kgm, 5.8 - 7.2lbft} from air bleed head until no (6) until no 3 - 157 WHEN MACHINE RUNS OUT OF FUEL When starting the en gine again after running out of f uel, fill with fuel, then bleed the air from the fuel system before starting the engine. l level and be careful not to run out of fuel. Always watch the fue l level and be careful not to run f the engine has stop ped because of lack of fuel, it is necessary to use the priming pump to bleed the air completely rom the fuel circuit.

The fuel injection pu mp and nozzle of this engine consi st of more precise parts than the conventio nal ones. If foreign matter enters them, it can c ause a trouble. Accordingly, if dus t sticks to the fuel system, wash it off with clean fuel. sidual pressure. When opening the ai r bleeding plug at the fuel filter hea d, take care. Fuel may spout because of re 1. Loosen air bleed plug (1) and (2) at the fuel mai 2. Loosen wing nut 3. Pump lever (4) to (5) holding lever (4) of priming pump out fuel from air bleed p left side of the fue out with the fuel. l main filter head until no more 4. Tighten air bleed plug (1) on the left side of the f 5.

Continue to pum p lever (4) and pump out fuel f ght side of the fuel main filter me out with the fuel. plug (2) on the ri more bubbles co 6. Tighten air bleed plug (2) on the right side of the head. Tightening torqu e: 7.8 - 9.8Nm {0.8 - 1.0kgm, 5. 7. Loosen air bleed er (6) at the side of supply pum where the fuel m ain filter is mounted. o pump out fuel from air bleed me out with the fuel. er (6). 8. Pump lever (4) t more bubbles co 9. Tighten air bleed Tightening torqu e: 4.9 - 6.9Nm {0.5 - 0.7kgm, 3. 10. Tighten wing nut (5) of priming pump (3) securel (4) in position.