. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING It is dangerous to charge a battery when mounted on a machine. Make sure that it is dismounted before charging. When checking or handling the battery, stop the engine and turn the starting switch key to the OFF position. The battery generates hydrogen gas, so there is a hazard of explosion. Do not bring lighted cigarettes near the battery, or do anything that will cause sparks. Battery electrolyte is dilute sulfuric acid, and it will attack your clothes and skin. If it gets on your clothes or on your skin, immediately wash it off with a large amount of water.
If it gets in your eyes, wash it out with fresh water and consult a doctor. When handling batteries, always wear safety glasses and rubber gloves. When removing the battery, first disconnect the cable from the ground (normally the negative (-) terminal). When installing, install the positive (+) terminal first. If a tool touches the positive terminal and the chassis, there is danger that it will cause a spark, so be extremely careful. If the terminals are loose, there is danger that the defective contact may generate sparks that will cause an explosion. When removing or installing the terminals, check which is the positive (+) terminal and which is the negative (-) terminal.
3 - 164 REMOVAL AND INSTALLAT ION OF BATTERY 1. Before removing battery, re touches between the positiv nuts of the terminal and rem 2. After installing the battery, f Tightening torque: 2 to 2.9 3. When installing the battery, Insert the hole of the termin Tightening torque: 5.9 to 9. 1. Before removing battery, re move the ground cable (normally connected to the negetive (-) t erminal). If any tool e terminal and the chassis, there is danger of sparks being gen erated. Loose n the ove the wires from the battery. ix it with the battery hold down. Nm {0.2 to 0.3 kgm, 1.4 to 2.2 lbft} connect the ground cable last. al on the battery and tighten the nut.
8 Nm {0.6 to 1.0 kgm, 4.3 to 7.2 lbft} 3. When installing the battery, al on the battery and tighten the nut 8 Nm {0.6 to 1.0 kgm, 4.3 to 7.2 lbft} REMARK There are two batteries each (to tal: 4) on both sides at the rear of the machine. Ther e is also o ne battery eac h for the ground (total: 2) on both sid es of the machine.