. MAINTENANCE SERVICE PROCEDURE 3. Remove outer element. 4 - 23 CLEANING OR REPLACING 1. Open cover (2) at the re ar of the operator's compartme 2. Remove lock (3) of the 4. Clean the inside and th e cover of the air cleaner body. 5. Direct dry compressed air (Max. 0.69 MPa (7 kg/cm 2, 99.4 PSI)) from the inside of t direct the compressed a again from the inside. 1) If the air cleaner immediately after t replace both the inn he outer element along its folds . Then ir from the outside along the fol ds, and clogging caution pilot lamp flashes he outer element has been cleaned, er and outer elements. NOTICE After cleaning and drying the e lement, check it by shining a light through it.
If any small holes or thin cra cks are found, replace the element . g. When cleaning the element, do not hit it or beat it against anythin Do not use an element that has damaged folds, gaskets, or seals. 6. After cleaning the elem ent, install it, then install cover ( 7. After cleaning and re placing the element, push th e dust indicator button to retur n the red display to its original p osition. REMARK After cleaning the ele indicator. If the dust indi the button is pressed, re ment, press the button of the dust cator shows the 5th stage even when place the element. After the element is clean ed or replaced with a new elem ent, the dust indicator may show the 3rd stage.