. MAINTENANCE SERVICE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING *1: When using Komatsu Supercoolant (AF-NAC), there is no need to use a corrosion resistor. When no corrosion resistor is used, use the special cover (600-411-9000). Please consult your Komatsu distributor about the method of installing. When using corrosion resistor, use Komatsu genuine corrosion resistor. If you use another corrosion resistor, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light metals such as aluminum. The coolant has the important function of preventing corrosion as well as preventing freezing.
Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine supercoolant (AF-NAC). If you use another coolant, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%.
When deciding the ratio of antifreeze to water, check the lowest temperature in the past, and decide from the mixing table given below. It is actually better to estimate and temperature about 10 ° C (18 ° F) lower when deciding the mixing ratio. The mixing ratio depends on the ambient temperature, but it should always be a minimum of 30% by volume (antifreeze/total amount of coolant x 100). Even in areas where it is not necessary to prevent freezing, use Supercoolant (AF-NAC) at a mixing ratio of at least 30% to prevent corrosion of the cooling system. The freezing temperature of undiluted antifreeze is -15 ° C (5 ° F).
Do not store undiluted antifreeze at a temperature of below -15 ° C (5 ° F). 4 - 25 Immediately after t he engine is stopped, th e coolan t is a t high temperature an d the radiator is under high i nternal pressure. If the c ap is re moved in this condition and th e water is drained , it will c ause burns . Wait for the temperature to go down, t hen turn the c ap slow ly to r elease the pressure. The e ngine i s run during the flushing ope ration. B efore standing u p from or l eavin g the operator's seat, always set the lock lever (work e quipment, steerin g) to the LO CK position.
For d etails o f the p rocedure when starting the engine, see "CHECK BEFORE STARTING ENGINE, ADJUS T (PAGE 3-72)" and "STARTING ENGIN E (PAGE 3-90)". go inside the rear of the machine. When the en gine is running, never go insi de the re ar of the machin Stop th e machine o n level g round when cleanin g or changing the coolant. Clean t he insi de of the cooling system, change the coolant according to the t able below. Antifreeze coolant Interval for cleaning inside of cooling system and changing antifreeze coolant Precautions for use Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first 1*