Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE BLEEDING AIR FROM BRAKE HYDRAULIC CIRCUIT CAUTION 1. After assembling the piping,be sure to check that the connectors are not loose. 2. Put blocks under the wheels. 3. Check that the brake oil level is within the sight gauge on the side of the brake oil tank. While the engine is stopped, the oil must be at level (A) (10 hours or more after the engine is stopped). While the engine is running, the oil must be at level (B) (5 minutes or more after the engine is started). 4. Stop the engine. 5. Remove the air bleeder cap from the brake housing and insert one end of a vinyl hose in the brake housing and put the other end in a container. 6.

Depress the brake pedal and loosen bleeder screw (1) to bleed air. After tightening bleeder screw (1), release the brake pedal slowly. This work are to be performed by two persons. One depresses the brake pedal, and the other bleeds air through the bleeder screw (1). Use the left-hand brake pedal. Supply brake oil periodically to keep the level sufficiently high. 7. Repeat this operation until air bubbles stop coming out of the hose. Then, depress the pedal to the end and tighten bleeder screw (1) while the oil is flowing out. NOTICE Bleed the air at all 4 locations. After bleeding the air, check the oil level in the brake oil tank. For details, contact your Komatsu distributor.

For details, contact your Komatsu distributor. 4 - 36 When adding oil to the brake oil t ank, always use the recommended oil given in "USE OF FUEL, COOLA ACCORDING TO AMBIENT TEMPE RATURE (PAGE 4-11)". After removing the piping of br ake hydraulic circuit,bleed the air from inside of the circuit as fo BLEEDING AIR FROM PPC CIRCUIT When removing piping of PPC circuit, or removing strainer, after assembling, bleed air from in follows: 1. Put bucket control lever in TILT position and lift arm control lever in FLOAT position, and a stroke end, keep in that po sition for one minute. 2.

Put bucket control lever in DUMP position and lift arm control lever in RAISE position, and a stroke end, keep in that po sition for one minute.