. MAINTENANCE SERVICE PROCEDURE ADJUSTMENT way. 4 - 41 1. Install adjustment b olt ( 1) an d locknut (2) t o yoke (3) 2. Tighte n adjustmen t bol t (1) u ntil the cl earance between pin (6) of the t ension pulle y (5) and the end f ace o f the oblong hole of yoke ( 3) is 0 mm, t hen tight en a furth er 6 t urns Lock s ecurely with locknut ( After o peratin g for 1 hour, if there a gap between pin (6) of tensio n pulley (5) a nd t he o blong hol yoke (3), he procedure in Step 2 to adjus t again. If there any m the fan belt, adjust in the