. MAINTENANCE SERVICE PROCEDURE WARNING NOTICE of U.L and L.L add the distilled a syringe to removed fluid with or battery 4 - 50 EVERY 250 HOU Maintenance for eve ry 50 and 100 hours service s hould be carried out at CHECK BATTERY ELECTROLYTE LEVEL Carry out this proce dure before operating the mac Do not use the batte ry if the battery electrolyte level i s below the LOWE R LEVE L line. This will accele rate deterioration of the inside of the battery and reduce the service life of the battery. In additio n, it ma y cause an explosion . ar the battery. The battery generat es flammable gas and there is da nger of explosion, do not bring fire or sparks ne Battery electrolyte i s dangerous.
If it gets in your eye s or on your skin, w ash it off with a large amou nt of water and consult a doctor. ed water to the battery, do not allow the battery electrolyte to go above the UPPER LEVEL line. If the oo high, it may leak and cause damage to the paint surface or corrode other parts.
When adding distill electrolyt electrolyte level is t oo high, it may leak and cause da mage to the paint s urface or corrode other part If th ere is danger of the electrolyte freezing if distilled wat er is added, add the distille d water before startin g operations on the nex day Inspect the battery e lectrolyte level at least once a month and follo w the basic safety proced WHEN CHECKING ELECTROLYTE LEVEL FROM SIDE OF BATTERY If it is possible to ch eck the electrolyte level from t he side of the battery, c 1. Use a wet cloth to clean the area around the electrolyte level lines and check that the electrolyte level is between the UPPER LEVEL (U.L.) and LOWER LEVEL (L.L.) lines.
If the battery is wiped with a dry cloth, static electricity may cause a fire or explosion. to clean the area around the that the electrolyte level i (U.L.) and LOWER LEVEL (L . If the electrolyte level is below the mid point marks, remove t water. . After adding dist illed water, tighten cap (1) se REMARK If distilled water is a If d lower the level to th e U.L. line. Neutralize the re baking soda (sodium bicarbonate), then flush it a amount of water or maker.