Komatsu — OPERATION

. SAFETY PRECAUTIONS FOR OPERATION 2 - 26 PRECAUTIONS WHEN TRAVELING Never turn the key in the starting switch to the OFF po sition. It is dangerous if the engine stops when the machine is traveling, because the steering becomes heavy. There is danger that this will cause misoperation of the steering wheel and may lead to serious personal inj immediately to stop the machine. When traveling or carrying out operations, always ury or death. If the engine stops, depress the brake pedal keep a safe distance from people, structures, or other ipment at ground.

If , the work chine to tip lever, stop e machine ment close danger of ng over to make the and do not e machine nd surface amage the machines to avoid coming into contact with them. When traveling on flat ground, keep the work equ height (A) of 70 - 90 cm (2ft 4in - 2ft 11in) above the the work equipment is to close to the ground surface equipment may contact the ground and cause the ma over. It is necessary to operate the work equipment control the machine first, then operate the control lever. Avoid traveling over obstacles when possible. If th has to travel over an obstacle, keep the work equip to the ground and travel at low speed.

There is more the machine tipping over to the left or right than tippi the front or rear, so do not travel over obstacles which machine tilt strongly to the left or right sides. When traveling on rough ground, travel at low speed operate the steering suddenly. There is danger that th may turn over. The work equipment may hit the grou and cause the machine to lose its balance, or may d machine or structures in the area. When using the machine, to prevent personal injury c aused by damage to the work equipment or by the machine overturning due to overloading, do not exceed the permitted load for the structure of the machine.

permitted performance of the machine or the maximum When passing over bridges or structures, check first that the structure is strong enough to support the weight of the machine. When operating in tunnels, under bridges, under elect ric wires, or other places where the height is limited, operate slowly and be extremely careful not to let the machin e body or work equipment hit anything. If you drive the machine at high speed continuously fo r a long time, the tires will overheat and the internal pressure will become abnormally high. This may cause the tir force, and this may cause serious injury or death. es to burst.

If a tire bursts, it produces a large destructive t your Komatsu distributor. n a slope, NEVER set the direction selector switch to the ed range. will not work, and this creates a dangerous situation. If you are going to travel continuously, please consul When the machine is traveling on flat ground or dow Neutral position. Always set it to a transmission spe If the transmission is at neutral, the engine brakes It may also cause damage to the transmission or personal injury or death. Neutral position.

Always set it to a transmission spe If the transmission is at neutral, the engine brakes It may also cause damage to the transmission or other parts of the power train, and this may lead to serious