. SAFETY PRECAUTIONS FOR MAINTENANCE switch OFF. Wait for For machines equipped with a battery disconnector switch, set the battery disconnector switch to the OFF position. For details, see "HANDLING BATTERY DISCONNECTOR SWITCH AND STARTING MOTOR DISCONNECTOR SWITCH (PAGE 6-24)". 2 - 40 Removing battery ca Before repairing th welding approx. 1 minute, t hen remove the negative (-) battery cable to stop the flow of electric Danger of sparks at sparks will be generated, so always observe the following.
There is hazard th Do not let tools around near the When removin connect the pos Tighten the batt Secure the batt There is hazard th at sparks will be generated, so always observe th e following. Do not let tools or other metal objects make any contact between the battery cables. Do not leave tools lying battery. g the battery cables, remove the ground cable (negative (-) cable) first. When installing, itive (+) cable first, then connect the ground. ery cable terminals securely. ery firmly in the specified position. When removin itive (+) cable first, then con nect the ground.
ery cable terminals securely Secure the batt ery firmly in the specified po PRECAUTIONS WHEN U SING HAMMER When using a hamm er, pins may fly out or metal particles may be scattered. This may lead to serious personal injury or death. . Always do as follows When hitting pins o r bucket teeth, there is a ha zard that broken pieces might be se nt flying and injure people in the surrounding area. Always chec k that there is no one in the s urrounding area. If hard metal parts such as pins, bucket teeth, c utting edges, or bearings are hit w ith a hammer, there is a ha zard that pieces might be scattered and cause serious persona l injury or death. Always wear safet y glasses and gloves.
If the pin is hit with strong force, there is a haza rd that it may fly out and injure peo ple in the surrounding area e surrounding area. . Do not allow anyone to enter th PRECAUTIONS WITH HIGH-TEMPERATURE COOLANT urting out when To prevent burns fro m boiling water or steam sp checking or draining t he coolant, wait for the cool ant to cool down to a temperature whe re the radiator cap can be to uched by hand. Then loosen the cap slowly to release the pressure inside the the cap. he radiator, and remove