. OPERATION EXPLANATION OF COMPONENTS ACCUMULATOR, HANDLING WARNING 3 - 70 On machines equip ped with an accumulator, for a short time after the en gine is stopped, if the work equipment control leve r is moved to the LOW ER position, the work equi pment will move down unde r its own w eight. K position. After stopping the engine, always place the w ork equipment l ock lever a nd parking lever in the LOC The accumulator is charged with high-pressu re nitrogen gas, so improp er operation may cause an e xplosion w hich wil l lead to serious injury or da mage. When handling the accumulator, al ways do as follows: Pressure in the control circuit cannot be c ompletely remo ved.
When removing t he hydraulic equ ipment, do not stan d in the direction that oil spurts out when performi ng the operation Loosen the bolt Do not disassem Do not bring it n ear flame or dispose of it i Do not make hol Do not hit it, roll it, or subject it to any imp When disposing of the accumulator, the g as must be relea sed. Conta ct your Komatsu distributor for proper disposa The accumulator is a device to store th e pressure in the contro circuit, and when it is installed, the contr ol circuit can b e operate for a short time e ven after the engine is stopped.
Therefore, if the c ontrol lever is moved in the direction t o lower th work equipment, it is possible for the work equipment to mov ight. is installed in the position shown in the diagram under its own we The accumulator is installed in the posit ion shown in t on the right. METHOD OF RELEASING PRESSURE IN OPERATING CIRCUIT ON MACHINE EQUIPPED WITH ACCUMULATOR 1. Lower the work equipment and stop the engine. 2. After stopping the engine, operate control lever full strokes to the front, rear, left, and right to release pressure inside the work equipment circuit.
However, the pressure cannot be completely released, so if accumulator in the work equipment circuit is removed, loosen the screws slowly, and never stand in the direction oil spurts out. ACCUMULATO 1. Lower the wo 2. After stoppin inside the wo However, the removed, loo 1. Lower the wo rk equipment and stop 2. After stoppin g the engine, operate c ontrol lever full strokes to the front, rear, left, and right to release pr essure rk equipment circuit. pressure cannot be completely released, so if accumulator in the work equipment circuit is and never stand in the direction oil spurts out. sen the screws slowly, and never sta nd in the d irection oi