Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION CHECK COOLANT LEVEL, ADD COOLANT WARNING problem. It occurs because too much coolant has been added. 4. After adding coolant, close the engine side cover. 3 - 74 Normally, do not open the radiator cap. When checking the coola nt level, check the sub-tank whe D o not remove the cap w hen the radiator coolan t is hot . Boiling coolant may spurt out. After the coolant temperature goes down, turn the cap slowly to release the pressure , then remove it. 1. Open the engine side cover on the left side of the chassis, and check that the coolant is between the FULL and L OW mark s on sub-tank (1).

If the coo lant level is low, add coolan t to the F ULL evel through the cool ant filler port in sub-tank (1 REMARK The coolant may overflow from the sub-tank drain hose. This is no 2. After adding coolant, t 3. I f the sub tank is emp ty, first check for leakage o f water, then l remove main radiator cap (2) and sub radiator cap (3), and check that the coolant water is above the bottom surface o f the strainer as shown in t evel is low.