. OPERATION OPERATION METHOD OF OPERATING PIN PULLER to the the "PULL OUT" (F)Front of the machine 3. Move the ripper up or down to set to the desired shank position. REMARK Align mark of ripper (A) with top surface of holder (B). (C) (D) (E) Depth Max. Depth intermediate Depth min. 4. Operate the pin puller control switch to insert the mounting pin. If the pin does not match the position of the hole in the shank, set the pin puller control switch to the "PUSH IN" position (2) and slowly move the ripper up or down. REMARK When raising the pin position to increase the digging depth, use a long protector to prevent wear of the shank. (F)Front of the machine 3 - 126 1. Stop the ground. 2.
Operate pin puller controller to position (1) and remove the mounting pin safe place and lower the shank