. OPERATION OPERATION PRECAUTIONS WHEN RIPPING set so that the top of the with the shank tilted travel during the ripping of the shank. When the shanks from the to travel over. 3 - 131 For the di gging angle shank is p erpendicula r, then lower the Do not car ry out rippi ng for long peri back. The tip of the p oint will wear to Do not c hange the This will he direction ore turning. direction of tr operation. changing t ground bef Never driv e in reverse when the ripp er point is inserte d in the bedrock. T he pin installing the point (1 ) will break and th e point will fall off. machine, tilt back (B) slightly, then raise the ripper Stop the slowly.
machine, After rippi ng, if the br mparatively large , avoid traveling o ver the hen traveling in r everse. When trav heating an eling in reverse (3), check t y large rocks. As far as poss he rear carefully t ible, choose level o avoid ground