Komatsu — INSTALLATION OF CAB

. OPERATION TRANSPORTATION installing the cab again. 3 - 140 REMOVAL OF CAB cab) (If equipped) ve the cab for transportation, disconnect (Machine equipped with If it is necessary to remo ve the cab for transportatio the wiring, and washer motor wiring before before 1. Pull the grommet port machine cover, then 2. Disconnect 4 washe 4-pin plug x 1) from t After removing, co prevent any dirt or Before removing t the cab and each etc.). Note the me 1. Pull the grommet port ion in towards the cab from t he hole in the machine cover, then remove. r hoses and the wiring (single wires x 2, he socket. 2.

Disconnect 4 washe 4-pin plug x 1) from t After removing, co ver the washer hoses with a vinyl bag to dust from entering. he cab, measure the clearance between Before removing t lever (joystick and blade asurements to use as a st control andard lever, when INSTALLATION OF CAB cab) (If equipped) e opposite order to removal. re disconnected. on top of the floor frame. the floor frame, then install bolts and - (U). ts in fully. Screw them in 3 or 4 turns. oles (N) - (U) fully. N), (U), (Q), (R), (O), (T), (P), (S). to (M), completely. (Machine equipped with Install the cab parts in th e opposite order to removal Connect all parts that we 1. 2. 3. 4. 1. Lower the cab slowly 2.

Align the cab with washers in holes (A) Do not screw the bol ts in fully. Screw them in 3 o r 4 turns. 3. Tighten the bolts in h Tighten in the order ( N), (U), (Q), (R), (O), (T), (P 4. Tighten the bolts, (A) If there are any uncle ar points about removing or installing the cab, please contact y our Komatsu distributor.