. OPERATION TROUBLESHOOTING 3 - 153 ENGINE ( ) : Always contact your Komatsu distributor when dealing with these items. In cases of problems or causes which are not listed below, contact your Komatsu distributor for repairs.
Problem Main causes Remedy Engine oil pressure monitor flashes when engine speed is raised after completion of warm-up Add oil to specified level, see CHECK BEFORE STARTING Replace cartridge, see EVERY 500 HOURS SERVICE ( Check, repair) ( Replace) Steam is emitted from top part of radiator (pressure valve) Add coolant, repair, see CHECK BEFORE STARTING Change coolant, clean inside of cooling system, see WHEN REQUIRED Clean or repair, see WHEN REQUIRED ( Replace thermostat) Tighten cap or replace packing ( Replace) Engine water temperature monitor remains alight altitude operation) Engine does not start when starting motor is turned Add fuel, see CHECK BEFORE STARTING Repair place where air is sucked in ( Replace pump or nozzle) See ELECTRICAL SYSTEM ( Adjust valve clearance) Exhaust gas is white or blue Add oil to specified level, see CHECK BEFORE STARTING Change to specified fuel Exhaust gas occasionally turns black Clean or replace, see WHEN REQUIRED ( Replace nozzle) ( Adjust valve clearance) ( Clean or replace, turbocharger) Combustion noise occasionally makes breathing sound Defective nozzle Lack of fuel (in Air) ( Replace nozzle) Add fuel Abnormal noise generated (combustion or mechanical) Change to specified fuel See item "Indicator of water temperature gauge is in red range on right side of gauge".
( Replace muffler) ( Adjust valve clearance) Monitor displays error code Please contact your Komatsu distributor Alarm buzzer sounds Engine horsepower lowered suddenly (Engine is running in duration mode)