. MAINTENANCE SERVICE PROCEDURE WHEN REQUIRED CLEAN INSIDE OF COOLING SYSTEM WARNING below. *1: When using Komatsu Supercoolant (AF-NAC), there is no need to use a corrosion resistor. When no corrosion resistor is used, use the special cover (600-411-9000). Please consult your Komatsu distributor about the method of installing. When using corrosion resister, use Komatsu genuine corrosion resister. If you use another corrosion resister, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light metals such as aluminum. *2: Permanent type antifreeze shall meet the requirements of ASTM D3306-03.
The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. Komatsu Supercoolant (AF-NAC) is strongly recommended wherever available. To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%.
When deciding the ratio of antifreeze to water, check the lowest temperature in the past, and decide from the mixing table given below. It is actually better to estimate and temperature about 10 ° C (18 ° F) lower when deciding the mixing ratio. The mixing ratio depends on the ambient temperature, but it should always be a minimum of 30% by volume (antifreeze/total amount of coolant x 100). 4 - 20 Immediately after t he engine i s stopped , the coolant is at a high temperature and th e radiator is under high i nternal pressure. If the c ap is r emoved to drain th e coolant in this conditio n, there i s a hazard of burns.
Wait for the temperature to go d own, then turn th e cap slowly to release the pressure before removing it. Cleani ng is c arried out with the engine r unning. When s tanding up or leaving the operator's seat , set the wor k equipment lock lever a nd th e parkin g lever to t he LOCK position. For de tails o f startin g the engi ne, see " CHECK BEFOR E STARTING ENGINE, ADJUS T (PAGE 3-71)" and "STARTING ENGINE (PAGE 3-92) " in the OPERATIO N sectio Never enter front th e machine when the engine is There is danger of t ouching th e fan. Stop the machine o n level gro und when cleaning or changing the coolant.
Clean th e inside of t he cooling system , change the c oolant a nd replace the corrosion resistor according to the t able Antifreeze coolant Interval for cleaning inside of cooling system and changing antifreeze coolant Replacing corrosion resistor Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first unnecessary(*1) Permanent type antifreeze (All-season type, *2) Every year (autumn) or every 2000 hours whichever comes first Every 1000 hours and when cleaning the inside of the cooling system and when changing coolant