Komatsu — CLEAN AND CHECK HYDRAULIC COOLER FINS

. MAINTENANCE SERVICE PROCEDURE 4 - 37 DRAIN WATER AND SEDIMENT IN FUEL T ANK ne has been at rest for a ays. Carry out t his procedure after the machi long time a nd after a lon g spell of rainy d Loosen val ve (1) at the b ottom of the fuel tank, and drain the water and sedime nt collected at the bottom of the tank together with the CLEAN STEERING CLUTCH CASE BREAT 1. Open t 2. Remov 3. Remov any dirt flushin 1. Open t he rear cover. 2. Remov 3. Remov e bolts (1), th e breather (3) en remove cove on the side of th stuck to the breather, then wash with clean diesel oil or g oil. REPLACE AIR CONDITIONER BELT 1. Loosen to the s 2. Replac Whe direc 3. Tighten V-belt.

(0.4 in) kg) at a pulley a 1. Loosen 4 bolts (1) an d jack bolt (2), th en move compress or (3) ide. e the V-belt. n adjusting the V-belt, do not push the compressor 2. Replac n adjusting t tly with the b jack bolt (2) ar. Use jack bolt and bolts (1), a (2). nd apply tension to the The standard deflection for t he belt is approx. 1 0 mm when presse d with a finger f orce of approx. 58. 8N (6 point midwa y between the ai r conditioner compressor nd fan pulle y. CLEAN AND CHECK HYDRAULIC COOLE If the hydra ulic cooler fin s are clogged or there is dirt caught in the fins, clean and check the fins. 1.

Open t he inspection cover on the rig mpressed ai g the hydrauli r to remove the c cooler fins. Ste mud, dirt, and l am or water may be eaves used of compress REMARK Check the hydraulic cooler hoses. If any hose is cracked or hardened b y age, replac e with a new hos e. Also check and ti ghten a ll loose ho se clamps.