. MAINTENANCE SERVICE PROCEDURE BLEEDING AIR IN HYDRAULIC SYSTEM 4 - 44 BLEED AIR FROM HEAD END OF RIGHT PITCH CYLIND (DUAL TILT DOZE Bleed t he air if the w ork equipment has been removed 1. Raise the blade and run the engine at low idling. 2. Operate the left and right tilt 5 to 10 times to bleed the air from t he tilt circuit. 3. Operate the for ward and rear pitch 5 to 10 times to bleed the air from the bottom end of the r ight cylinder. 4.
Set the left and r ight cylinders at the neutral position , then carry o ut the following operations 5 - 10 t imes to bleed the air from the head end of the righ t pitch cylinder (1) Forward pitc h → (2) Left tilt → (3 ) Right tilt → ( 4) Rear pitch See "OPERATIONS AND CHECKS AF TER STARTIN G ENGINE ( PAGE 3-97)". Since t he engine m ust be started and th e blade must be operated, see OPERATION NOTICE If the engine is run at h igh speed immediately after startup or a cylinder is pus hed up to i ts stroke end, air take n inside the cylinder may cause damage to 1.
Bleeding air fro 1) Run the eng ine at low idle, and extend and ret ract each cyli nder 4 to 5 times, taking care tha t a cylinder is not moved t o the end of its strok e. (Stop the cy linder approx . 100 mm (3.9 in) short of its stroke end) 2) Next, opera te each cylinder 3 to 4 times to the end of its str 3) Finally, oper ate each cylinder 4 to 5 times to th e end of its s troke to c ompletel y remove t he a ir.