. MAINTENANCE SERVICE PROCEDURE CHECK ALTERNATOR DRIVE BELT TENSION, ADJUST CHECKING Depress a belt at a mid point between drive pulley (1) and and the cover touches any moving part of the alternator. 4 - 49 alternator pulley (2) with a th umb to apply 98 N (10 kg) - pre and when deflection amount (A) remains between 13 mm a mm (0.51 in and 0.63 in), the deflection is within the standard ADJUSTING bolts (6) (2 places), and remo 1), (2), and (5), then turn nut ( 1. Remove cover mounting cover. Loosen bolts and nuts ( adjust the belt tension. 3. After adjusting, tighten bo lts and nuts (1), (2), and (5), to s alternator (3) in position. 4. Reinstall the cover remo ved in step 1.
Confirm that no REMARK Check each pulley for bre akage and wear of the V-groove . In particular, check that the V-belt does not tou ch the bottom of the V-groove. d, ask your Komatsu distributor for replacement of the pulley. ned that it cannot be adjusted any more or if it has any cuts or cracks, replace it. If any abnormality is foun d, ask your Komatsu distributor for replacement of the pulley If the V-belt is so lengthe ned that it cannot be adjusted a ny more or if it has any cuts or cracks, replace it When adjusting the V-bel t, do not press the alternator dir ectly with a bar, but put a wo od piece, etc. in-between them.
If the V-belt has been repl aced with a new part, there will be initial elongation, so inspe ct and adjust it agai n after one-hour of operation.