. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE (F)Front of the machine 3. Remove drain plug (P2) in the strainer cover, and drain the oil (approx. 4 liters (1.06 US gal)) collected inside the piping. 4. Loosen mounting bolt (6) of the power train strainer, then remove cover (7). 5. Remove spring (8), then remove strainer (9). 6. Remove any dirt stuck to strainer (9), then wash it in clean diesel oil or flushing oil. Wash the removed parts and the inside of the case at the same time. 7. Loosen mounting bolt (10) of the scavenging pump strainer, then remove cover (11). 8. Remove strainer (12). 9.
Remove any dirt stuck to strainer (12), then wash it in clean diesel oil or flushing oil. Wash the removed parts and the inside of the case at the same time. 10. Install the strainers in their original position. 11. Replace the power train filter element. For details, see "REPLACE POWER TRAIN OIL FILTER ELEMENT, STEERING LUBRICATING OIL FILTER ELEMENT (PAGE 4-58)". 4 - 65 2. Remove inspection cover (3 ) in the undercover at the bottom s. front (front of machine).
bottom rear of t he machine as follow 1) Remove 2 bolts (4) at the front (front of machine 2) Hold cover (3) in position a nd gradually r emove 2 bolts (5) at the re ar (rear of machine) water may flow when doing this.) 3) Lowe r cover ( 3) gradually to open it. (The front o f the cover is attached by a hinge.) e the strainer at portion (P). If you look up, you can se e the strainer at portio n (P). at the