Komatsu — CONTROL LEVERS, PEDALS

. OPERATION EXPLANATION OF COMPONENTS ADJUSTING FRONT-REAR POSITION OF RIPPER CONTROL LEVER (Range of adjustment: ± 40 mm (1.6 in)) Lever (8) position can be adjusted to best suit the operator's physique. Follow the steps below for the adjustment. Adjustment within range of 40 mm (1.6 in) from neutral to rear 1. Loosen lock nut (1) with a wrench. 2. Set lever (2) to the optimum position. 3. Tighten lock bolt (1) with the wrench to hold lever (2) in position. Adjustment within range of 40 mm (1.6 in) from neutral to front 1. Remove lock bolt (1) with a wrench. 2. Remove lever (2) and reverse it 180 ° 3. Install lever (2) to lever (5), then set it to the optimum position. 4.

Tighten lock bolt (1) with the wrench to hold lever (2) in position. 5. Loosen nut (3). 6. Reverse knob 180 ° . 7. Tighten nut (3). (F)Front of the machine PIN PULLER CONTROL SWITCH (IF EQUIPPED) Switch (9) is used to operate the pin puller. (a) PULL OUT: Pin is pulled out. (b) PUSH IN: Pin is pushed in. (F)Front of the machine 3 - 48