. OPERATION MACHINE OPERATIONS AND CONTROLS GENERAL OPERATION INFORMATION display. 3 - 123 Traveling Traveling over boulders, tr ee stumps, or other obstacles wi ll cause a big shock to the chassis (and in particular to the tracks), and this will cause damage to the m achine. For this reason, always remove any obstacles or travel ar ound them, or take other steps t traveling over such obstac If there is no way to avoid travel speed, keep the wor k equipment close to the ground, and try to travel so that the center of the track passes over the ob stacle. High Speed Travel On uneven roadbeds such as rock beds or uneven roads wi th large rocks, travel at Lo speed.
idler in the forward directio When traveling at high speed, set the n. eed, press travel speed selector displayed as Lo, Mi, or Hi on the switch monitor Permissible Water Depth NOTICE When driving the machine out of water, if the angle of the machine exceeds 15°, the rear of the upper str ucture will go under water, and wate r will be thrown up by the cooling fan. This may cause the fan to break. iving the machine out of water. Be extremely careful when dr Do not drive the machine i n water deeper than the center o f carrier roller (1).
Supply grease to the parts which have been under water fo r a long time until the used grease is projected out of the bearings ( around the bucket pin, in particula r).