Komatsu — BUCKET REPLACEMENT AND INVERSION

. OPERATION MACHINE OPERATIONS AND CONTROLS BUCKET REPLACEMENT AND INVERSION WARNING while standing at the side for the work. Replacement 1. Place the bucket in contact with a flat surface. and then remove the bucket. the link (6) with holes 3 - 129 When pins are knocked in wi th a hammer, pieces of metal may fly and cause seriou tion, always wear goggles, hard hat, gloves, and other protective equi When the bucket is removed, If pins are hit with a strong for ce, there is a hazard that the pin may f ly ou t and i njure p eople in the sur rounding area. Make sure rrounding area before starting the operation. When removing the pins, do n ot stand behind the bucket.

In additio n, be extremely ca reful not to put y our foot under the b ucket When removing or inserting pins, be extremely careful not to get y our f ingers caugh Never insert your fingers into the pin holes when aligning the hole Stop the machine on a firm a nd flat surface and do the work. W hen performing join t work, ap point a lead and f ollow that person's instructions an d signals. REMARK When removing the pins, p contact with the ground. lace the bucket so that it is in light gly to the ground, the resistance will fficult to remove the pins.

If the bucket is lowered stron gly to the ground, the resistance be increased and it will be di NOTICE After removing the pins, make su re that mud or sand does not get on t hem. Dust seals are fitted at both ends of the bushings, be careful not to damage them. n the stopper bolt for arm pin (A) and olt, pull out arm pin (A) and link pin (B), ket. es (1) of the replacement bucket and ), then insert grease-coated pins (A) hole (2) respectively.