Komatsu — MACHINE INSPECTION AFTER DAILY WORK

. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS 3. Lower the bucket horizontally until the bottom touches the ground. MACHINE INSPECTION AFTER DAILY WORK 3 - 134 4. Set lock lev er (3) in the LOCK positi 5. Check the engine cooling water te mperature and engine oil oil pressure wi If the coo to cool u the engin see "TRO If the eng immediat see "TRO pressure wi th the machine monitor. If the coo lant temperature gauge i s in the red rang e, allow it ntil the indicator enters th e. For details of the insp e black range, t ection and actio hen stop n to take, UBLES AND ACTIONS ine oil pressure monitor ely. For details of the ins (PAGE 3-154)".

lights up, stop th pection and actio e engine n to take, UBLES AND ACTIONS (PAGE 3-154)". 6. Stop the en gine. For details on the p rocedure for stoppin g the engine, see "STOPPING THE ENGI NE (PAGE 3-107)". 1. Walk aroun d the machine and check the work equipment , machine exterior, and under carriage, also check for any leakag e of oil or coolant. If any p roblems are found, r epair 2. Fill the fuel 3. Check the e ngine compartment for p aper and debris. Clean ou t any paper and debris 4. Remove an y mud affixed to the und