Komatsu — LIFTING MACHINE

. OPERATION TRANSPORTATION LIFTING MACHINE WARNING 3 - 146 The operator ca rrying out the lifting oper ation using a c rane mu st be a properly qualified crane o Never raise the machine with any worker Always make su re that the wire rope is of ample strengt h for the weight When lifting, ke ep the machine horizontal When carrying o ut lifting operations, set th e lock lever to the LOC K position to prevent the machine from moving unexpectedly. Never enter the area under or around a ra ised machine. Never try to lift the machine in any posture o ther than the p osture g iven in the procedure below or u sing lifting equipment other than in the proced ure below.

hat the machine may lose its balance. There is a hazard t hat the machine may lose NOTICE ng applies to the standard specification machine. ng differs according to the attachments and options installed. This method of lifti ng applies to the standar d specification machine The method of lifti ng differs according to the attachments and options For details of the p rocedure for machines th at are not the standard specification, please consult yo ur Komatsu distributo For weight, see " SPECIFICATIONS (P AGE 5-2)". flat ground as follows. When lifting the machine, carry out the operation on flat ground as 1.

Start the engine, then the swing the upper structure so that the work equipment will be on the side of sprocket (1). 2. Extend the bucket cylinder and arm cylinder fully, then lower the work equipment to the ground as shown in the diagram on the right using the boom cylinder. 1. Start the eng ine, then the swing the upper struct ure so t hat the work equipment will b e on the side of spr ocket ipment to the ground a s shown in th e diagram 3. Set the lock lever securely to the L OCK position 4. Stop the eng ine, check that there is nothing aro und the operator's compartment, then get off the machin Close the ca b door and front glass securely.